- Active Posts:
- 336 (0.18 per day)
- Most Active In:
- Tools 'n' Tips (309 posts)
- 01-March 08
- Profile Views:
- Last Active:
- May 09 2013 11:28 PM
- Member Title:
- Tenax Sniffer (Open a window!)
- 73 years old
- July 31, 1939
- Fullerton Calif.
- Website URL:
Posts I've Made
04 February 2013 - 10:47 PMThe opening for air around the Neo CN nozzle is very narrow. There is a picture on this page. It puts out just a breath of air. If the nozzle has any flare at all it will restrict it even further. You might want to have a look at yours with a magnifier.
I would contact Iwata. They say they will stand behind the Neo, and I've found that to be true.
14 January 2013 - 05:48 PMI think this is what you want. The Iwata airbrushes have 1/8 inch connections. The Badger threads are proprietary.
28 December 2012 - 04:54 PMWell said, Denstore.
27 December 2012 - 02:06 AMOr maybe an HP-CR with a .5mm nozzle.
15 November 2012 - 04:29 PMHi Lenny,
The trigger pin passes through a little rubber O-ring. You can see a picture of it on this page. Notice it has some lubricant on it. If you get lacquer thinner on it, it will swell and jam. The same goes for the tiny O-ring below it.